Cedar Arrows

Unless you buy your arrow shafts pre-prepared, making your very own cedar arrows can be a long and difficult procedure; although completion results can be exceptionally pleasing.

Cedar Arrows

There are mainly 3 parts in an arrow- the stack or head, the shaft and the nock.

Make the Shaft first

To make the shaft the very first thing you have to discover the most appropriate wood (see my post of the different types of wood offered). Choose your sapling for the arrow from the straighter and thicker ones.

Seasoning the sapling

Fresh timber has a very high amount of wetness and hence is not usable as it is, so you have to season them. Bundle your saplings and put the bundle outdoors. Keep them off the ground and try to allow air to circulate. The more air that gets at the wood, the quicker it will dry. Place the wood stack in a warm area to season it the quickest. Untie the package after a couple of weeks and peel the bark thoroughly. When ended up, connect them again and dry under the sun up until they are all set.

If like me you don’t frequently have access to sunny weather condition, attempt and find someplace warm inside your home.

Size them up

When the saplings are all set, it’s time to size them up. Generally cedar arrows are 28 to 30 inches in length and 5/16 inches in size, although this depends upon your draw length and bow poundage. Add a few additional inches to the length so that any mistakes can be covered later on.

Correct the alignment of the shaft

Your cedar arrows need to be straight and the straightness depends upon the shaft. Heat is used at first to correct arrow shafts as well as for regular maintenance. Fill your daily kettle or steam iron with faucet water. Pass the length of the arrow back and forth through the steam for 5 to 10 seconds, till the wood has actually softened. Find bends on the sapling and carefully correct the arrow. Check for straightness by placing the pointer of the arrow in your palm and spinning the arrow. A smooth spin indicates straightness and any jerk will need more working. When you are encouraged that the shafts are corrected, let them rest for 2 weeks. If bends still appear you need to repeat the heating procedure once again.

Fitting the Nock

After correcting the alignment of the arrow the next step need to be cutting nocks on one end of the shaft. Make one end of an arrow shaft into a cone shape, which slips into the plastic nock (you can select these up online or from many archery stores). You can utilize a saw tooth or a hacksaw, and utilize sand paper to sand completion into a cone shape so that the plastic nock can move on.

Cedar Arrows


Fletchings are needed to stabilise your arrows in flight. The bigger the fletchings you utilize the faster your arrows will stabilise, but the more arrow speed you will lose. Consider exactly what range you will be shooting, and the poundage of your bow. Select 3 feathers, either natural or manufactured feathers. Your fletchings don’t want to be longer than about five inches long, and must be connected with fletching glue or wood contact cement. To make sure you place the cedar arrows correctly, utilize a fletching jig. You can cut feathers to consistent shape with a sharp set of big scissors. The lighter the arrowhead the smaller the plumes can be.

Place the arrowheads

The next action is to place the arrowhead. A range of pointers are offered, so consider what you will be utilizing the arrow for. Don’t utilize a hunting idea for target archery for instance.


Cresting an arrow makes it simple to distinguish in between particular cedar arrows. Use a waterproof paint and embellish the arrow accordingly.

That’s it! A lot of work, however the outcomes can be really worthwhile. If you are looking for more information on cedar arrows, please visit: https://www.atcarchery.com.